TOSHIBA TOCP100 Fiber Optic Cable (20 cm) FO Connection

Buy online your TOSHIBA TOCP100 Fiber Optic Cable (20 cm) FO Connection from our e-store Cnc-shopping, specialist in CNC machine-tools spare parts.

The TOSHIBA TOCP100 optical jumper is a short fiber optic cable designed to transmit data between electronic boards and modules equipped with TOCP-series optical interfaces. It is an ideal replacement cable or spare part for CNC controls, servo drives, and I/O modules that rely on optical communication to ensure reliable signal transmission and high immunity to electromagnetic interference.

With a length of 20 cm, this optical interconnect is perfectly suited for short-distance connections between devices installed within the same control cabinet or equipment rack. Its compact design allows clean cable routing while reducing mechanical stress on connectors and minimizing the risk of excessive fiber bending.

The cable is commonly used to connect motion control boards, servo drive interfaces, and communication modules incorporating TOSHIBA TOCP optical transceivers. It provides stable optical signal transmission, helping maintain dependable communication between CNC control components in demanding industrial environments.

Maintenance technicians frequently use this model to replace damaged or aging optical cables when diagnosing communication failures, link alarms, CRC errors, or intermittent data loss. Keeping a spare cable available allows fast troubleshooting and minimizes production downtime during maintenance operations.

Each cable is tested to verify optical continuity and signal transmission before shipment. Connector ends are protected for safe transport, and every unit is covered by the Cnc-shopping warranty. Repair, exchange, and obsolete part sourcing services are also available for control boards using TOCP optical interfaces, helping extend the service life of legacy CNC systems.

Frequently asked questions about TOCP100:

How do I confirm this cable fits my application?
Check that both devices use TOSHIBA TOCP-style optical receptacles and that a 20 cm run reaches comfortably without sharp bends. If your modules specify TOCP optical ports, this jumper is typically suitable for cabinet-internal links.

Is 20 cm sufficient to replace a longer jumper?
Shorter optical jumpers work if the routing allows a gentle path with no strain at the connectors. Ensure the devices are close enough on the same panel or rack and avoid tight bend radii during installation.

Where is this cable intended to be installed?
It is designed for use inside protected electrical enclosures. For areas exposed to coolant, chips or mechanical impact, route the link within the cabinet and keep connectors capped until mating.

Can this be used to diagnose intermittent communication faults?
Yes, it is commonly used as a known-good CNC replacement component during troubleshooting. Swapping a suspect jumper with a verified unit is a fast way to rule out fiber damage or poor connector mating.